Enum GeometricDefect

pub enum GeometricDefect {
    VertexOffCurve {
        edge: usize,
        error: Scalar,
    },
    PcurveOffCurve {
        loop_id: usize,
        use_index: usize,
        error: Scalar,
    },
    UnevaluableCurve {
        edge: usize,
    },
    UnevaluablePcurve {
        loop_id: usize,
        use_index: usize,
    },
    UnevaluableSurface {
        loop_id: usize,
        use_index: usize,
    },
}

One geometric inconsistency, with enough detail to locate it.

Variants

VertexOffCurve

An edge endpoint does not lie on the edge’s own 3D curve.

Fields

edge: usize

Index of the offending edge.

error: Scalar

Distance from the vertex to the curve point, in model units.

PcurveOffCurve

A pcurve, lifted through its face surface, does not follow the edge.

This is the defect a purely topological audit cannot see: the trim curve resolves and the loop closes, but the face boundary runs somewhere other than the edge it claims to trim.

Fields

loop_id: usize

Index of the owning loop.

use_index: usize

Position of the edge use within that loop.

error: Scalar

Worst sampled deviation, in model units.

UnevaluableCurve

An edge’s 3D curve could not be evaluated on its stated interval.

Fields

edge: usize

Index of the offending edge.

UnevaluablePcurve

A pcurve could not be evaluated on its stated interval.

Fields

loop_id: usize

Index of the owning loop.

use_index: usize

Position of the edge use within that loop.

UnevaluableSurface

A face surface could not be evaluated at a pcurve sample.

Fields

loop_id: usize

Index of the owning loop.

use_index: usize

Position of the edge use within that loop.

Trait Implementations

impl Clone for GeometricDefect

fn clone(&self) -> GeometricDefect

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for GeometricDefect

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl PartialEq for GeometricDefect

fn eq(&self, other: &GeometricDefect) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for GeometricDefect

impl StructuralPartialEq for GeometricDefect